ATTENTION - the aluMATTER site is currently experiencing some technical problems
 
blank spacer
blank spacer
  Home | Site Contents | Search | aluSelect | Partners | About aluMATTER | Help  
Milling

Leonardo da Vinci, Helsinki Award 2006, Design and execution: Gerold Fink, Austria. Click to open PDF document about this award

Leonardo Da Vinci Helsinki Award 2006

Leonardo da Vinci, Helsinki Award 2006, Design and execution: Gerold Fink, Austria. Click to open PDF document about this award

Bronze medal for an outstanding project promoting and supporting the LifeLong Learning EU policy. Award Berlin 2007

 
Click to go to the previous page in this section Page 5 / 29 Click to go to the next page in this section  
Cutting Parameters

A milling operation is characterised by the following parameters:
ap: Axial engagement of the tool, also known as the axial pass depth in mm.
ae: Radial engagement of the tool in mm.
N: Rotational speed in rev min−1.
vc: Cutting speed in m min−1.
fz: Feed per tooth in mm tooth−1.
vf: Feed rate in mm min−1.
Q: Material removal rate in cm3 min−1

Authors/Contributors